HELP
Can someone change post from imperial to metric its just standard fanuc 18 xzc post, i have compost 2
but need compost 3 to compile it
thanks
HELP
Can someone change post from imperial to metric its just standard fanuc 18 xzc post, i have compost 2
but need compost 3 to compile it
thanks
Send me i could compile in metric.
Enviado desde mi iPhone utilizando Tapatalk
hi, I am new. I need to change this post that is in inches, to metric. could someone help me? thank you. my e.mail is: [email protected]
Hello Ajesms, I hope you can help me as well! I have a Gibbs post, that comes out in Metric with the advanced 3d tile, but Imperial with 5d tile. The person that made it claims that it must be my Gibbs settings!, but I cannot find any settings. I suspect the post needs to be modified in several places for different process's! Is this true? I would really appreciate help solving this? Thanks Mark
Send me it for change it.
Enviado desde mi iPhone utilizando Tapatalk
Hello Ajesms,
thanks for your help in fixing my problem with my Gibbscam post being Inch when using 5-axis, and Metric when using Advanced 3D. I really would appreciate if you could change it to all be metric.
I also have another problem with the post that I hope you may be able to help or advice me with. When I make a process with the “Advanced 3D tile” that uses the “Rotate” and “duplicate” feature, the posted GCode only performs the operation process ONE time only, and does not duplicate it. (It "repeats" and "duplicates" with the “5 axis tile” but not with the “Advanced tile”) . I have been told that I need a different post processor, not the post that I have attached.
again I very much appreciate your support.
Mark
[email protected]
Please check your private mail from CNC zone.
All the problems that you have is possible solve.
Enviado desde mi iPhone utilizando Tapatalk