[ErnieD]

Does anyone know if Tormach will be printing a comprehensive manual for PathPilot? I have installed v1.6 and am having some problems with such things as "append to file" and others that do not come to mind at this time. If I want to do a simple facing program where I move to Z, feed in X, raise to clear, rapid back to start, rapid to Z, finish cut in X, raise to clear, rapid back to start and load next part. I would like to either do this by MDI or with a sub routine. Any foresight will be appreciated,

Ernie

[tmarks11]

It is available here:

http://www.tormach.com/uploads/897/U...A_Web-pdf.html

Just like when mach3 was the program of choice, the instructions for use are in the 770 and 1100 operator manuals.

I don't think you will see a dedicated manual just for PP, as it is not offered except with the mills and the lathe.