Lowering Voltage on Power Supplies?
Howdy all,
Here is what I got.
My 1100 oz/in servos are rated @ 48 VDC .33 amps no load.
I'm using 320 Geckos.
Right now I've got two power supplies hooked up @ 52 VDC 16 amps.
I have three 52 VDC 8 amp power supplies available to me.
I'm getting 132 ipm with my 8 tpi ACME now on rapids which is livable but hey I can handle more.
Now if I hook two up to get 104 VDC how can I downgrade the volts to get 70 or so volts?
I was told a rheostat might work?
Any thoughts?
Regards,
Dasigntist
Never forget that only dead fish swim with the stream
Malcolm Muggeridge