[hotiron]

Hello All,

I recently purchase a Mori TV-400. Basically everything was fine on the initially power up homing on all axis and everything, but I messed up by manually actuating the tool changer arm trying to get familiar with functions of panel. I am not nearly as saavy with troubleshooting the Mits like I am the Fanucs. Right now the tool changer arm is hanging down and the z axis is in an interlock state and wont jog/home. The tool changer arm wont home either until the z is satisfied I believe. Can you tell me what parameters will temporarily release the interlocks? I tried Y1C2 param from reading on practical machinist, but it only unlocked the Z+ direction.

Thanks,

Blake

[underthetire]

Those do have the custom page to manually move the ATC, but I'll be damned if I can remember how on the old touch screen. The interlock release is 99 input before you enter the ATC manual page. If it will take an MDI command, you can use M33 to disable the interlocks as well. Could do it in a minute if I was standing in front of it.

[hotiron]

Thanks...I will try M33 and see what happens. The X & Y axis will jog, but the Z is inhibited Due to the tool arm not retracted.