I replaced the power supply on my laser and it only has the high voltage output, Where do I connect the cathode line? The old power supply had a separate blue cathode wire
I replaced the power supply on my laser and it only has the high voltage output, Where do I connect the cathode line? The old power supply had a separate blue cathode wire
No idea but a pic would help maybe.
In case anyone is wondering, I'm the twin of the other gfacer on cnczone...
This is the power supply I purchased
80W 80Watt Laser Power Supply for CO2 Laser Engraving Cutting Machine AC110V | eBay
My guess is that you might see it once you remove the case. It looks like they just did not add pass through? On my old decommissioned 150W supply it going into the end of the transformers directly and its not a screw or anything that I could replace or add on. So is it there if you open the case (fingers crossed).
In case anyone is wondering, I'm the twin of the other gfacer on cnczone...
Oh its not an issue, I've done it plenty. But looks like a lightobjects model and they should know the story. Its not there in the pictures so I think you'll need to open the case anyhow. Its more a cover really.
In case anyone is wondering, I'm the twin of the other gfacer on cnczone...
There is a terminal post on the end of the PSU with the Anode wire. Could this be it? I assumed it was a ground connection. You can't see it in the pictures because it is behind the rolled up anode wire. Might even be what that is tiewrapped to
You'll only know if you crack open the case... Sounds likely though.
Sent from my LG-D852 using Tapatalk
In case anyone is wondering, I'm the twin of the other gfacer on cnczone...