[travis174]

Hope anyone can help me out. We got a DMU50V in an auction and finally got it powered up the other day and I get a few errors. E01 whch is interface missing and i can clear it then when I hit the on button I get E15. Which in the book says input spindle/feed halt is low. Any ideas? the only thing the machine will do is engage the draw bar. I cannot get any of the Axis to energize and move and the spindle will not turn. I got all the manual except electrical and service.

[senthil1783]

Hii Friend,

I am having DMU50V millplus model.
My machine hard disk got crashed.
I need hard disk backup of your machine.
Can you please help.

regards
senthil kumar
India

[Eldiiar]

Hi Travis did you solve your issue with "E15 input spindle/feed halt is low"? I got the same error((

[Eldiiar]

Solved, the problem was in the spindle cooling system, so the spindle overheated and this error message appears.

[Nik86]

i see you have machine deckel maho dm 50. I bought machine . I need help ? How to call renishava to measure tools?
Many thanks

[SRG_1]

Hello
Does anyone have a BIOS photo of a 1996 DMU 50V working machine, Philips PG1220 Series, Grundig Millplus control, 5 axes. Interested settings:
1. Submenu "Memory Shadow"
2. BIOS Embedded Extension Configuration BIOS Extension Base Address
3. EXM menu

My e-mail: [email protected]
Thank you very much.