Looking for control retrofit options for a hydraulic press brake. Will be removing the mech activated servo valves and setting up a Y1 Y2 servo valves with linear encoders. Looking for something like a simple fill in the blank format for in for like punch # die # etc, and then able to do the same to build a small multi bend program entering the bend angle, length , finger ht, crown, etc. Also wanting a display of posistions. Would like to have it setup so that with minimal training almost anyone could walk up to it and program a simple bracket.

Machine has a X, R back gage and motor controlled crowning. Electronic controlled pressure valve as well.

I looked into Fasfold, and while it is really neat and would do everything I want, its a bit out of my budget. Looked and Camsoft non G code version with a 8 axe galil card, and while it would probably work, have heard alot of bad stories about them. Mach 3 won't do the closed loop needed for the hydraulic valves.

Its an old Komatsu PHS 80x255, current control inop and bad boards.