[Jeffmartin]

Hello Everyone,

I bought a chinese 50w laser engraver and cutter 3 months back. It got corel laser and laserdrw softwares. corellaser didnt work and I was working with laser draw software. It worked fine before but now while engraving the machine is disconnecting and connecting continuously. Sometimes the machine stops and starts again after 3 seconds. Iam getting the message " Engraving machine is disconnected -

1. If the machine is not powered, Please power on

2. If the machine is offline, reconnect it

3. If prepare to cancel current task, please click [cancel]. Error Id : 0 "

Iam getting this message only when I set high current for cutting acrylic. It gives a laser firing sound and then it stops cutting but the laser nozzle moves around without cutting. Iam setting current regulation 8 (I think it is mA. Iam not sure as Iam new to CNC and laser cutting) while engraving and while cutting 10 and keep the speed 2mm/s. If I go beyond 10, then the machine disconnects.

The information which I found on the machine
mainboard: 6C6879-LASER-M2

device id: 492B4D1F3D015F57


Could anyone help me solve this issue ?