I booted up my vanguard 3400 this morning and a message come up on my dos screen. above the "press Pause to resume", a message above read Table 1 relocated origin, x=0.000 y=0.000, once complete my file I try to send it to the engraver and is says to "PRESS SET ORIGIN AFTER GO TO XY.
I reset set origin on mogul and it read x=0.000 and y=8.000 once i send the file over it is not recognizing the correct origin. Any suggestion on what I can do. I hope my problem is explain well enough for you to follow.
I tried to reload the program again, but no luck