When i draw a circle on coreldraw, and then send it to corelaser plugin to make a cut. It always cuts twice.

It traces the circle, and the traces the same circle back. This is annoying, as i can't get clean cuts.

Is there something i can do? I'm using 0.5 (or hairline) line width in coreldraw and 1000dpi. Is it related somehow to the line width?


PS. Ok, maybe i should have done the google thing first... hah. Set the line width as low as it goes (0.00085pt).. and bingo. This also explains why my cuts where 0.5mm too small.