[LEARN]

Anyone know where I can find a drawbar ? 1/2-13 thread fir a nmtb spindle

[LEARN]

To the top. I emailed charter oak about a week ago and no response . Send another email last night as well.

[GITERDUN]

Oil hardened threaded rod from MSC

[LEARN]

What about the nut on top ?

[sudip]

may be this can help you. Tool clamping and declamping problem in the spindle of Batliboi machine.

[LEARN]

Just received an email 25$ so I'll be buying new

- - - Updated - - -

No your spam post does not help

may be this can help you. Tool clamping and declamping problem in the spindle of Batliboi machine.

[LeeWay]

What caused the first one to go bad?
If it wore out, then I would consider making my own. The replacement is likely the same grade material as the original. I use grade 8 threaded rod and coupling nuts. I bore through the nut and insert a roll pin. I find that it even has a better fit in the threads on the collet than the original DB.

[Runner4404spd]

kbc tools has them.

[GITERDUN]

Use a coupler nut and turn it to fit inside your spindle, thread it on and then thread on another and weld it to the threaded rod. That's what you will get from the other guy for 25.00- for the same price you could make 3 yourself.

[LeeWay]

Sometimes it is easier to buy than to make, however this is such a simple project that it takes virtually a few minutes work. You can be certain about the quality of the end result too. Not only that, but once you order the rod and nuts, you have future backup stock. I actually replaced my drawbar on my brand new machine when I received it. That way I know what it is made of.