[cyberkeith]

This morning I found that when I switched from standard jog mode to microstep mode each axis move 1 inch now before stopping.
I am at a loss at what in the world I did to change this. It worked fine before jogging only 1 step at a time. everything else functions fine..
Thank you in advance for pointers

[vmax549]

Press the {TAB} key and then select whatever step length you want. Then press tthe {TAB} key again to return to the screen.

(;-) TP

[hub]

You can also change the steps by pressing Alt + J
(Press Ctrl + J to change the jog mode; btw Cont. <-> Step.)

[cyberkeith]

Thank You, Thank You.... That was the problem. Don't know how I managed to change that setting, but it is great to know it is there!