Re: VF3 366 unused alarm
Near as I can see the problem is in the line you are getting an error in. Because your previous lines moves X to X3.5, how can it it move to the same location again and move the Y distance. If you are trying to move in a full circle, X3.5 full circle to X3.5, you can't do it with an R or radius move with a Haas control. An "R" move must be 180 Deg or less.
G1X3.5
G3X3.5Y-.5R.5 (This is where the cursor is when I get the alarm)
Of course we don't know why you are invoking cutter comp in the first place or what diameter you are calling up.
Mike
Two Haas VF-2's, Haas HA5C, Haas HRT-9, Hardinge CHNC 1, Bother HS-300 Wire EDM, BobCAD V23, BobCAD V28