[jorgehrr]

Please I need help!!!


My machine
Nakamura TW10 18i-T
Fanuc.

Problem:
I lost my home position, still dont know how, from a shut down of two days this issue appear. Anyway I reset it by using Parameter 1815.
It looks ok now, I may need to twick it a bit...My problem now is the TURRET POSITION. Turret is indexing to the wrong number position.
Sample:
Program reads T0101 machine will index to position number 2 (T0202). How do i reset this???
Please someone out there help!!!!!!

George

[sinha_nsit]

Watch it more carefully. At least the offset number can't change.

[fordav11]

ignore post#2, its total bullsh!t

assuming your turret is servo driven your parameter 1815 will have lines for X, Z and 3 (or some other axis letter/number for the turret servo)
all you have to do is put the turret to the physical position where tool #1 should be and toggle 1815.4 of the TURRET SERVO line to 0, then 1.
power off/on and your #1 turret position should be good.

[sinha_nsit]

Again started bark!ng.
Some people never change.

[jorgehrr]

Fordav11-
Thank you for your replay...

I was sure this is the parameter I need to play with, but I dont know witch letter, I have X Y Z A. I used
X 1815 .4 to reset my X home position, I think A is for the turret, Im just not sure. I dont want to make things worse.
But....after your coment Im gone go for it. "A" has to be for the turret.
Thank you my friend
Regards
George

[zavateandu]

if you go in parameters at number 3115 on the line of A you will have 0 and you can change it to 1 and the A axis will be displayed on screen along with X ,Z .
In this moment if you make tool change you will see if A will change from 30 degrees to 30 degrees and you are 100% sure the A axis is for servo turret
after that you put on tool 1 on turret and reset the 1815.4
when finish put back the 3115 parameters to 0 and the A axis will disappear from screen.

[fordav11]

yes, normally the turret servo is hidden, but the parameter will be 1 to hide. so you need to change it to 0
either way the turret servo is usually not named with a letter because its not seen and it is normally a number. if you have other axes it could be 5 (XYZA, so 1,2,3,4 is used and 5 is next)