What is the normal cable layout to connect two devices with 9 Pin D-Profibus interface?
Is this correct?
Pin 3 to Pin 3 (P)
Pin 8 to Pin 8 (N)
Cable shield to both chassis D-Sub
Best Regards,
Manuel
What is the normal cable layout to connect two devices with 9 Pin D-Profibus interface?
Is this correct?
Pin 3 to Pin 3 (P)
Pin 8 to Pin 8 (N)
Cable shield to both chassis D-Sub
Best Regards,
Manuel
Here is a page at siemens that describes the cable and pinouts.
http://support.automation.siemens.co...id99=&x=20&y=8