[Matamaure]

Hi,

Your machines look very interesting. I have a few questions.

What is the work area of the Raptor 30*36?
What's the overall envelope including the stepper motors? I already have an enclosure and I wonder if it would fit in it...
Can you provide a mount for a 80mm round spindle?

I already have my Nema23 electronics. Would the kit be pre-drilled for Nema 23?

Thanks in advance,

Mathieu

[gio666]

Hi,

Your machines look very interesting. I have a few questions.

What is the work area of the Raptor 30*36?
What's the overall envelope including the stepper motors? I already have an enclosure and I wonder if it would fit in it...
Can you provide a mount for a 80mm round spindle?

I already have my Nema23 electronics. Would the kit be pre-drilled for Nema 23?

Thanks in advance,

Mathieu

Work area of 30x36 is 24x30 , with steppers on it is around 36 x42 footprint .
I have spindle mounts for 80mm ,65mm and 56 mm round. Hitachi , porter cable and Tekno motor spindle .All direct bolt on
Yes all machines come with Nema 23 mounts , Predator and Demon have a bolt on Nema34 mount

[Matamaure]

Work area of 30x36 is 24x30 , with steppers on it is around 36 x42 footprint .
I have spindle mounts for 80mm ,65mm and 56 mm round. Hitachi , porter cable and Tekno motor spindle .All direct bolt on
Yes all machines come with Nema 23 mounts , Predator and Demon have a bolt on Nema34 mount

What about the overall height?

[gio666]

What about the overall height?

All depends on where you mount Z axis and length of bolts to mount to table. 24 to 30 inch

[Matamaure]

All depends on where you mount Z axis and length of bolts to mount to table. 24 to 30 inch

This height includes the z-axis stepper?