[turboprogrammer]

for 4th axis work, it alarms, problem is its a twisty part so when I take off the g93 and run the feed at 200.imp when theres a straight none twisting move its way too fast of a feed
and a ton of code

any idea of what code this machine need

fanuc control
O-MD

[zavateandu]

i think you need to sit down and take a deep breath and try to explain once again what is your problem because for me is no sense at all.

[turboprogrammer]

could be you just don't understand English so well being in/possibly from Romania?

yang mill
fanuc control
alarms when using g93 command for 4 axis simultaneous movement feed command

any substitute command for this older machine/control?
thoughts or ideas

[dcoupar]

It would help if you told us what alarm you are getting. My guess is the option isn't turned on.

[turboprogrammer]

im finding more out each time I go to that place, its a side gig for me

I found out that this machine must have the tool change code like this
M6 T1

I found out that it must have the code for the axis unclamp in the program,
M11

neither of these ive ran into before, and before it wasn't moving but I bet that was because of the lack of the m11 code, and im going to give it another go with the g93 in there today
but if I remember it may have given me a p/s alarm, but ive tried so many things so far I cant remember, and think im just about to crack this case and get to making parts