I have a old camtech router at least 20 yrs old, after moved to a new location, the x and y move in opposite direction and the Z do not move at all, I heard the sound try to move a bit and it stop.
the power button suppose to turn off but the machine still has light inside, very rare.

it is the type that still need the small control panel to get it to run function key and move left and right type.
What might be wrong? any suggestion.

worst case, since this is a 4x8' router, and look like all the motors are still working, is that a good idea to rebuild using the new controller like mach3 type of software to drive it.
right now it is using tcpwin, a very basic software.
what is the good forum for look into this
thanks.