584,837 active members*
5,332 visitors online*
Register for free
Login
Page 2 of 2 12
Results 21 to 23 of 23
  1. #21
    Join Date
    Apr 2011
    Posts
    20

    Re: Shizuoka AN-S

    I do not have a source for one. I planned to measure/engineer one and then machine it. I'll make several when/if I get it done. I would appreciate the opportunity to buy one if someone else goes through the exercise. Measurements of a good one would be very much appreciated, too.

  2. #22
    Join Date
    Mar 2015
    Posts
    1

    Re: Shizuoka AN-S

    How did you pull the Y axis ball screw? Did you have to remove the knee? I am rebuilding the X/Y axis on a Shizuoka AN-S mill. Thanx!!

  3. #23
    Join Date
    Apr 2011
    Posts
    20

    Re: Shizuoka AN-S

    So my belt finally popped! It seems like I have to wind the screw that moves the yoke for the variable width pulley all the way out and then the variable pulley assembly should pull all the way off. Happily it seems to have slid off the end of the splined shaft down into the gearbox. I too have sheared the nylon back gear if anyone has a source. I fear I'll have to reverse engineer it and machine one... It figures I broke the belt an hour after everyone closed for the weekend.

Page 2 of 2 12

Similar Threads

  1. Shizuoka B-3V help
    By petek in forum Uncategorised MetalWorking Machines
    Replies: 14
    Last Post: 12-07-2021, 03:18 PM
  2. Need help Shizuoka
    By elmeys in forum Uncategorised MetalWorking Machines
    Replies: 5
    Last Post: 01-03-2020, 05:42 PM
  3. Shizuoka
    By ozzie34231 in forum Knee Vertical Mills
    Replies: 1
    Last Post: 06-14-2018, 01:00 PM
  4. Shizuoka Cnc An-s
    By SHIZUOKA in forum CNC Tooling
    Replies: 3
    Last Post: 10-27-2011, 05:15 PM

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •