ngr1- Norman;
I don't have xylotec drivers - BUT if you check the Toolbar in MACH2 - pull down , go to and map (label the pins you're using/need to use) for MACH2 to the config your board has. Double check the config and always hit the button! You'll have to sort out the requirements with a xylotec user.
I struggled a bit - but that seems like thats what your asking for. Else email ART directly -- his turn around is quick and encouraging. I hate to say it but the very thorough 250 page manual IS worth printing out - do it doublesided though. Good Luck!
:cheers: Jim
Experience is the BEST Teacher. Is that why it usually arrives in a shower of sparks, flash of light, loud bang, a cloud of smoke, AND -- a BILL to pay? You usually get it -- just after you need it.