[rustyolddo]

Has anyone dealt with this problem? I need to replace the wiper material in my way covers, not a big job in itself, problem is finding the wiper material. I estimate I need about 50 feet to do all of the covers, about 36" per wiper. I can get the material from Hurco
P/N 6190001015, WIPER, WAYCOVER, VM1/2/3, $290/meter

$4700 for rubber strip is asinine. I checked a number of the companies that make the material but none seem to have the profile used on a Hurco.

[FannBlade]

I would be interested in this answer also.

[deputydawg]

This link was way shorter before I cut and pasted it, but it's basically waywiper.com. There's been previous posts here before as well that may have other suggestions.


Way Wipers, rubber wipers, slideways, way wiper

[rustyolddo]

Here are some close up pics of the profile, it wipes with both a front facing lip & a rear facing lip and is retained by the hump resting in the channel.

Attachment 286082

Attachment 286084

[rustyolddo]

This link was way shorter before I cut and pasted it, but it's basically waywiper.com. There's been previous posts here before as well that may have other suggestions.

No go, sent them a pic and they don't have that profile wiper.

[deputydawg]

I found another place that may have something. It's mimwaycover.com

[rustyolddo]

I pulled a cover to remove a piece for a pic and measurement. It measures 12mm wide. The rear tail is about 3mm, middle 4mm and the lip about 5mm

[Jls343]

Did you ever find any wipers that work? I need the same for a vm2.