I have my control connected to the FTP server and want to run the DNC programs from the FTP server.
It's posible?
thank you very much
Popex
I have my control connected to the FTP server and want to run the DNC programs from the FTP server.
It's posible?
thank you very much
Popex
Fanuc 0i-MD - from software version 37 or 38 it is possible. Sorry, can not remember right version, but from middle of March, 2015
Try to find parameter 14885. If present, set bit1=1. The soft version can be seen on SYSTEM-SYSTEM
Attachment 286068
Very well, I'll try.
Thank you very much!
Fbu Hello, unfortunately I do not have that ... not have been available parameter control is available for the modification of that value. I have 0i-MD.
Thank You
DNC via ethernet is an option. if you don't have the option you won't see that parameter or have that functionality.
either way, if the function was only available from the middle of March 2015, you are unlikely to have it unless you bought your machine new within the last 3 months.....
for software version, as stated above, press SYSTEM hard key then SYSTEM soft key. software version is available there by using page up/page down to find the screen with software versions.