Originally Posted by
toolnuts
Hi all,
I'm a newbie that's struggling with V13.1.1012
I've got 3 shapes, 2 rectangles and one circle.
I've split the two rectangles (mid point split of a line segment), I've defined Pilot holes (notes) for all of the figures
($P1, $P2, and $P3) , and start notes ($S1, $S2 , and $S3) as well. I did contours for all three. The CON ( # ) complete
was announced after each contour. (CON(0), CON(1), and CON(2)).
I look at the NC gallery and all three contours are listed.
I go through to the Wire EDM Module, but only the first contour is listed in the go-round,
lower left panel, but all three contours are listed in the upper left panel.
What am I doing wrong?