[SPENG]

I have an Omax cnc waterjet 5x10 cutting area 50,000psi.

Price is a flat $1.25 per minute
You are responsible for material costs
You are responsible for cad work and providing us with either the cad file or a DXF file.

Turn around time is usually 1-2 days from receiving material and in most cases is just a flat 2 day turnaround on most orders.

There is no minimum waterjet time, however you are responsible for all of the material costs and need to decide if we are shipping the remainder material alone with parts to you or if the remainder material will be "donated" to us if any exists

We use UPS for all shipping and are located in CHANDLER, ARIZONA

Pretty straight forward to get parts cut and we will help where we can. Shop time is limited in resources for cad design work but we can help if you have the budget to allow for our cad time which is at a reasonable $50 an hour.

Attached are a few photos of my shop.


Attachment 288266Attachment 288268Attachment 288270Attachment 288272

[rbjem]

Roughly where are you located?

Sent from my SPH-L720T using Tapatalk

[SPENG]

Roughly where are you located?

Sent from my SPH-L720T using Tapatalk

I am in Chandler, Arizona

[Alax7]

I'll have to take you up on this. Was in need of a big 20" disk out of 3/8" steel and was quoted a ridiculous amount locally. Should I message you for the shipping address?

[SPENG]

I'll have to take you up on this. Was in need of a big 20" disk out of 3/8" steel and was quoted a ridiculous amount locally. Should I message you for the shipping address?

Shoot me a pm that works just fine. 20" isn't big 60" is big and we do those for manhole covers out of 3/4" ever so often.




This is with a cut quality of 5 (best quality) if you have to be inside a price range we can lower this quality, just get what you pay for. anything above 2 will be not terrible.