Heard noise coming from the spindle, pulled the cover, and the spring on top of the drawbar was loose. I tightened it back down, and heard an air leak in the back of the machine, so I replaced the air line coupler (elbow) under the pressure regulator. Now when I apply air to the machine, the drawbar comes down, if I push the "tool in/out" button, the drawbar goes up (backwards from how it should be). Any ideas?
Results 1 to 2 of 2
-
08-04-2015, 04:20 PM #1
Registered
- Join Date
- Oct 2012
- Posts
- 2
Stupid drawbar issue with Fadal VMC15XT.
-
08-04-2015, 07:33 PM #2
Registered
- Join Date
- Oct 2012
- Posts
- 2
Re: Stupid drawbar issue with Fadal VMC15XT.
Something is triggering the drawbar solenoid to be open......
Reply With QuoteSimilar Threads
-
single phaze 22volt fadal VMC15XT
By rob jerico in forum FadalReplies: 9Last Post: 04-09-2018, 01:01 PM -
Need Help getting my Fadal VMC15XT (1998) to 'boot up'
By segvargas in forum Community Club HouseReplies: 0Last Post: 10-05-2013, 06:33 PM -
Fadal VMC15XT Servo amplifier fault on all axis
By Kizmo in forum FadalReplies: 4Last Post: 11-15-2010, 04:37 AM -
What should the drawbar pressure be on a Fadal VMC 15?
By Edster in forum FadalReplies: 10Last Post: 11-04-2006, 01:12 AM -
Drawbar spring question on fadal vmc15
By Edster in forum FadalReplies: 3Last Post: 02-10-2006, 04:47 PM
Tags for this Thread
Posting Permissions
