[frizi]

Hello everyone.

I am new to posting here, but have used the forum to find plenty of information.

I would like to ask anyone for help with a Yasnac J50 control. It is on a Hyundai SPT-V30T Drill Tap center. I am looking for information on upgrading memory or the possibility of DNC to the machine. Currently the memory is 40m of tape (approx. 125kb of memory). This machine does not have a tape function on the selector switch to allow DNC operation, and the manuals are very limited in explaining if DNC is possible. It does have an RS-232 port for transferring programs, however it seems to only be able to transfer to memory.

Any information is greatly appreciated, including a contact to someone who may have information on upgrading the memory, if possible.

Thanks
Rick Frye

[ncbobbys]

Rick... I can help you upgrade the memory. If there is no Tape Mode selection then upgrade would be the only option.
Email me at [email protected]