[skubajon]

Hello. I'm in process of getting my machine put together and now working with my ac servo drives.

I think I understand the theory behind electronic gearing but looking for a little advice I guess.

My encoders are quadrature 2500 count so 10000 count per rev. I'm running 5mm ball screw with a 2:1 belt reduction system. Now if I leave this setting to default 1:1 at 500 khz this thing will be dog slow.

Is there a good calculation to use where I can figure out this setting as well as able to tell mach what my pulse per unit is?

Sent from my SM-N910V using Tapatalk

[skubajon]

Nobody? I'm wanting to run this setup at about .01mm per pulse as my goal. I need to be able to cut the pulses into about half so that if I send say 10000 pulses to the drive, the encoder will stop after 20000 quadrature counts

Sent from my SM-N910V using Tapatalk

[mactec54]

skubajon

What Servo Drives are you using, most Drive manuals will tell you how to set the Electronic Gearing

[skubajon]

I purchased some aasd drives. The manual shows how but of course not what to set.

Sent from my SM-N910V using Tapatalk