Re: Does the Center Line of the Y Axis Line up with the Center Line of the Table T-Sl
You could always ditch the t-nuts and drill locating pins and threaded holes into the table itself, with the plate located perfectly...
It does seem strange that they didn't locate the holes on the fixture plate off center so the plate would be centered correctly.
I don't think the fault here is in the mill, but in the design of fixture plate. I doubt any mill in existence has the center slot perfectly aligned at the center of travel. I could be wrong, but that is not a feature that jumps out as important.
You should provide feedback to Tormach. This seems like such a simple thing for them to get wrong, and so easy to correct.
Tim
Tormach 1100-3, Grizzly G0709 lathe, Clausing 8520 mill, SolidWorks, HSMWorks.