[lettersetc]

This wasn't a problem last week, and I installed Enroute 5 on a new computer and added all the same machine drivers and everything, but now when I start a job, the spindle won't start. Any ideas?

[syon]

This wasn't a problem last week, and I installed Enroute 5 on a new computer and added all the same machine drivers and everything, but now when I start a job, the spindle won't start. Any ideas?

If it was working before the install, i would check the gcode for the S parameter (SPINDLE SPEED), as well as the M parameter to turn it on (M19,20 CLOCKWISE,COUNTER CLOCKWISE,ETC)

[lettersetc]

So here is some GCode from a job, I don't see an M19, M20.

M90
G90
G70
G75
G97 S18000
G00 CTCInsert 3/16" End Mill
G00 X20.191 Y3.1531 Z-0.5
M12
G01 X20.191 Y3.1531 Z0.473 F15.0
G01 X20.191 Y4.3234 Z0.473 F150.0
G02 X20.2414 Y4.6455 I21.0786 J4.3494
G02 X20.312 Y4.7617 I20.5911 J4.5124
G02 X20.5147 Y4.8709 I20.5852 J4.4975
G02 X20.7046 Y4.8904 I20.6935 J4.0619
G01 X21.5015 Y4.8904 Z0.473
G02 X21.7538 Y4.8694 I21.5297 J3.7024
G02 X21.7778 Y4.8631 I21.6807 J4.5458
G02 X21.9194 Y4.7662 I21.6831 J4.5727
G02 X21.9915 Y4.6538 I21.5867 J4.4734
G02 X21.9976 Y4.6351 I21.868 J4.6034
G02 X22.0067 Y4.5588 I21.492 J4.5359
G02 X22.0132 Y4.2918 I17.8685 J4.3243
G01 X22.0132 Y2.1249 Z0.473
G02 X21.9705 Y1.7253 I20.4854 J2.0863
G02 X21.9059 Y1.5854 I21.5748 J1.8231
G01 X21.9012 Y1.5796 Z0.473
G02 X21.7688 Y1.4953 I21.6805 J1.7799
G02 X21.4582 Y1.4531

[MCPservice]

Which machine are you using and which driver did you choose in the set-up