[aninventor]

I have an early model Dynapth system 10 to sell.
I was told it was a working system when I bought the mill and removed it.
It does not come up with nothing attached to it but a power cord - so condition/problem is unknown.
It is missing the top and side cover panels but is otherwise as removed and complete.
The NC computer was driving a Siemens Simoreg DC servo amp and power supply and that is for sale as well.
That servo amp system is 3 phase input so I can not test it. It is very clean - looks near new.
The Siemens servo motors and tachs may be for sale some time soon - depending on a decision to go with step motors or servos.

Open to offers on some or all.

I do not have any documentation.


Lee

[bill south]

Where are you located?
Bill

[aninventor]

I live just a bit north of Ft. Worth, TX

[mikecolee]

Hi Lee,

I have had a similar experience to yours with an old DP10 system... Ended up replacing the MCU with new hardware and using Mach 3. Happy to share my experience with you are still in decision making phase...

Mike

[aninventor]

I will be traveling from Ft Worth to Columbus OH via 35, 44, 70 sometime later this month.

I live just a bit north of Ft. Worth, TX