Hey there, just recieved my G Weike 1290! I'm up and running and cutting away but I'm still having a big problem. I set up all the paramiters on the Lasercut 5.3 software and the placement and size of the artwork looks right but when I actually start to run or test for the cut the laser won't use the full bed. For instance if I create a solid line that runs across the full 1200mm bed the laser only runs half way across the bed. That's when I start it from the upper right hand corner or the "Datum" position. Also, the I made the line in the center of the work space the line is actually being cut across the top of the bed and not the center. If I make a circle, wherever I move the x&y to is where it creates the circle. So from the datum position, even if my circle is in the center of the laser work area, the laser only moves about an inch and cuts the circle in the upper right hand corner. Not sure what's going on here, any help?
Thanks!