Hi, Why i see extra circular movement in mach3 ?!
it's correct in Solidcam
Attachment 297046
But in Mach3:
Attachment 297048
?!!!
Thanks in advance.
Hi, Why i see extra circular movement in mach3 ?!
it's correct in Solidcam
Attachment 297046
But in Mach3:
Attachment 297048
?!!!
Thanks in advance.
Change your IJ mode in Mach3.
Gerry
UCCNC 2017 Screenset
http://www.thecncwoodworker.com/2017.html
Mach3 2010 Screenset
http://www.thecncwoodworker.com/2010.html
JointCAM - CNC Dovetails & Box Joints
http://www.g-forcecnc.com/jointcam.html
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)
Usually from absolute to incremental on I,J (or vice versa) in the config screen.
Or change your SolidCam post to send it differently, whichever is easiest.
sarsali
The same as what Gerry has said, this is where to change it, open the General Configuration File you want it to look like this photo, this then should match your G-code program
Mactec54