585,973 active members*
4,138 visitors online*
Register for free
Login
IndustryArena Forum > CNC Electronics > Viper Servo drives > Trying to get the Viper BX7 to work

Thread: Trying to get the Viper BX7 to work

Results 1 to 2 of 2
  1. 11-15-2015, 10:42 PM #1
    vegastony12
    vegastony12 is offline
    Join Date
    Jul 2014
    Posts
    13

    Trying to get the Viper BX7 to work

    Hello all! trying to get the breakout board BX7 to work with a VFD, Just cannot figure it out? upon sending the command from Mach say S1000 =10v is OK and S500=5v ETC..Fine, but trying to turn on and off a 12v relay is a NO GO! Anyone have a BX7 with any success? Any help is greatly appreciated.

    Thanks
    Reply With Quote Reply With Quote
  2. 12-03-2015, 05:29 AM #2
    Larken
    Larken is offline Member
    Join Date
    Feb 2007
    Posts
    966

    Re: Trying to get the Viper BX7 to work

    Send me your XML file and i will take a look at it.

    Larry
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Similar Threads

  1. Viper 20/25 VTL
    By Dbear in forum Tutorials
    Replies: 0
    Last Post: 02-12-2015, 03:25 AM
  2. Trying to get Viper tune to work
    By Danno in forum Viper Servo drives
    Replies: 1
    Last Post: 08-13-2013, 03:30 AM
  3. Viper 250 ??????
    By jeep534 in forum Viper Servo drives
    Replies: 2
    Last Post: 04-08-2012, 07:58 PM
  4. Best Breakout board to work with Viper 200's and Mach3?
    By CATCH22 in forum Viper Servo drives
    Replies: 2
    Last Post: 01-10-2012, 10:14 AM

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules