Is there a way to add some lines in the gcode that will reset the manual feed and RPM override on Path Pilot? I try to remember to check these before I start a cycle, but I have missed it a couple times. It would be nice if this could be done in gcode, then I could just modify my post processor to always include it at the start of a program.
Results 1 to 3 of 3
-
11-18-2015, 06:14 PM #1
Member
- Join Date
- Apr 2012
- Posts
- 161
Reset Feed & RPM overrides with gcode
"You can't teach stuff in a school that you would learn in real life unless the real life people are in charge of the school." - Gene Sherman
-
11-18-2015, 06:50 PM #2
Registered
- Join Date
- Jul 2004
- Posts
- 81
Re: Reset Feed & RPM overrides with gcode
I'm not sure how to reset the settings, but you can use M49 to disable the overrides. See M48 and M49 - Override Control
or http://linuxcnc.org/docs/html/gcode/...#mcode:m48-m49.
-
11-18-2015, 10:56 PM #3
Member
- Join Date
- Apr 2012
- Posts
- 161
Re: Reset Feed & RPM overrides with gcode
That's good to know, but I still want to be able to use the overrides. I wonder if disabling then enabling the overrides would reset it to 100%. Probably not, but I'll have to try it just to make sure.
"You can't teach stuff in a school that you would learn in real life unless the real life people are in charge of the school." - Gene Sherman
Reply With QuoteSimilar Threads
-
Predator overrides
By robrea in forum BobCad-CamReplies: 3Last Post: 05-27-2010, 05:04 PM -
Feed Hold vs. Reset Button
By georgebarr in forum Mach MillReplies: 2Last Post: 07-03-2009, 10:10 PM -
feed hold switch reset
By davelbert in forum TorchmateReplies: 3Last Post: 05-11-2009, 09:08 AM -
Is there a way to feed an offset in manually in Gcode
By seanreit in forum Uncategorised MetalWorking MachinesReplies: 6Last Post: 12-14-2008, 04:30 AM -
I have a problem with my gcode or my conversion to gcode , everything is tiny?
By NickLatech in forum G-Code ProgramingReplies: 0Last Post: 03-10-2005, 07:46 PM
Tags for this Thread
Posting Permissions
