[forhire]

I've been using the EZ-Digitize software on my TC3G. I've been able to do basic things but I'd really like to get a copy of the "EZ-Digitize Reference Manual". Does anyone have a copy of the manual? The best I've found is a list of g-codes from the EZ-Trak manual but no syntax details. I'm flying blind without a manual.

DIGITIZING CYCLES (OPTIONAL SOFTWARE)
*G200 Digitizing Cycle OFF/CANCEL
G201 Basic - Digitize Points, Lines, Arcs
G202 Mesh - Digitize XY Mesh
G203 Z-Trace - Trace Z Normal
G204 XY-Trace - Trace XY Boundary
G205 Cross-Section - (Trace)

[Olds455]

I've been using the EZ-Digitize software on my TC3G. I've been able to do basic things but I'd really like to get a copy of the "EZ-Digitize Reference Manual". Does anyone have a copy of the manual? The best I've found is a list of g-codes from the EZ-Trak manual but no syntax details. I'm flying blind without a manual.

DIGITIZING CYCLES (OPTIONAL SOFTWARE)
*G200 Digitizing Cycle OFF/CANCEL
G201 Basic - Digitize Points, Lines, Arcs
G202 Mesh - Digitize XY Mesh
G203 Z-Trace - Trace Z Normal
G204 XY-Trace - Trace XY Boundary
G205 Cross-Section - (Trace)

Have any luck on this? I am trying to set up my TC1.
Thanks

[forhire]

Have any luck on this? I am trying to set up my TC1.

The manual is here:
https://www.cnczone.com/forums/bridg...ml#post2111982

This thread most of what I know.