[grege101]

I have an old custom machine with a Fanuc Series 15-M PMC and 14 axis'. I need to do some modifications to the ladder program but I am currently unable to upload it from the PMC. I've tried FAPT Ladder I, II and III with no luck. I've also tried using a Handy File without any luck. Is it even possible to upload the ladder program using a pc? Or is this model too old?

I would appreciate any advice or assistance.

Thanks,

Greg Elliott
Controls Tech

[debco99]

Hi Greg,

I write quite a few ladders but have never done one for a 15, however I have the manual for all Fanuc pmc's and will get all the information in the morning.

If you still need it then, maybe someone will have the answer before.

I cant remember if the 15 pmc was in eprom or not if so thats a problem.

Regards

[debco99]

Hey Greg,

I will be out on service until tomorrow finishing up a retrofit, I will scan the pages you need and get them to you on Saturday.

Thats about the best I can do.

Regards

[grege101]

Hey Greg,

I will be out on service until tomorrow finishing up a retrofit, I will scan the pages you need and get them to you on Saturday.

Thats about the best I can do.

Regards

Sounds good to me debco99. Whenever you get a chance that would be great!

Thanks,

Greg

[debco99]

Greg, I have the information you need (pdf's) get in touch with me at
[email protected]

Regards

[mtto]

Hi I have a problem

I need to open a pmc ladder RB2 but whit the version 3.4 and 4.2 is impossible

can you help me?