Hi
Experimenting with 1/8" HDF. Onsrud gave some help with bit selection but I am still trying to dial in my feeds and speeds to get a clean edge with no "fuzz". Any ideas are appreciated. Thank you.
Greg
Hi
Experimenting with 1/8" HDF. Onsrud gave some help with bit selection but I am still trying to dial in my feeds and speeds to get a clean edge with no "fuzz". Any ideas are appreciated. Thank you.
Greg
What bits are you using?
Gerry
UCCNC 2017 Screenset
http://www.thecncwoodworker.com/2017.html
Mach3 2010 Screenset
http://www.thecncwoodworker.com/2010.html
JointCAM - CNC Dovetails & Box Joints
http://www.g-forcecnc.com/jointcam.html
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)
Hi
Onsrud 66-092 on 1/8" thick HDF
Thanks
Greg