to post pics, simply upload them to your computer through a scanner or digital camera, save them to a file (my documents, my pictures, etc.), and then on here, click on Go Advanced under the message box. There is a small paperclip icon that will be above the message screen, click it. Click on one of the Browse icons, and then locate the file in your computer. Click on it to open, then click on upload. Close that small upload screen, and click on the paperclip again, select the picture. It will enter it into your response.
I think that should cover that....
I am not familiar with Cadlink, but IMO the machine might take either DXF input or Gcode, which opens the door to a lot of different drawing programs, as well as CAM programs. I would look and see what kind of file Cadlink outputs and go from there.
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)
"If the women don't find you handsome, they should at least find you handy"
-RedGreen show.