[NWArtist]

Does anyone out there have a Boss Laser and is working with photo engraving? I have only been working a little over a month, with my machine and I am looking for different editing software for my photos. With just the basic RV8 Works that comes with the laser, I can transfer photos, yet unable to maintain the good 3-D quality from the portrait. Any suggestions?

[BigGerry]

I think if you use the initial high resolution of the photo, then further use will be able to maintain the quality of the image

[Eddie54]

Is it possible to increase the resolution of a photo without losing quality? For example, I take a poor quality photo and use Photoshop to enlarge it to Full HD, but it only gets worse. The image becomes blurry, and it is impossible to distinguish anything at all.

[BigGerry]

Of course, you can't do it that way. That's not how it works. You are just stretching the image.

[BigGerry]

You are just stretching the image. You need to increase the number of pixels. I can't give any universal advice for Photoshop, because each version does it differently. I use https://imglarger.com/enhancer for such purposes. Since this site is very easy to use, you just upload a photo and increase the resolution by 200%, 400% or 800%. And a lot of other tools. I usually do photo processing here, as you can improve color correction and contrast.