I am trying to start up a new to me 1995 Miyano BND34T2 and having issues.
Current issue: Machine Alarm Lamp is ON
Only Diagnosis Alarms are:
300.0 - Main turret stop position Alarm
300.3 - Main turret position detection alarm
I changed batteries, followed the Turret Re-Teach procedure which changed the Machine Alarm Lamp from ON to FLASHING, removed the 300.0 & 300.3 alarms, allowed me successfully command tool change in MDI (after turning off PWE and zeroing all axis). However Machine Alarm Lamp continued flashing and upon power cycle both 300.0 and 300.3 and Machine Alarm is back ON, not flashing and tool does not show position in the bottom right corner of the screen as it did on power off. I have been able to manually index both turrets the entire time before and after all of this.
The machine did have a bar feeder that did not come with the machine so I turned of parameter 312.6 (existence of automatic bar feeder) thinking perhaps it was waiting for a signal.
I am getting a little desperate to get this machine alive after 2 weeks of googleing and searching here.
Pictures of current codes and pages associated pages attached.
Thank you for reading!
links to HIGH RES pics
pages:
http://i27.photobucket.com/albums/c1...107_071643.jpg
http://i27.photobucket.com/albums/c1...107_071635.jpg
http://i27.photobucket.com/albums/c1...107_071547.jpg