[stevieboy]

Hi Guys,

I've just taken delivery of a 2001 XYZ 710 with a Siemens Shopmill 810D control. Most of what I do is programmed offline using Onecnc. I'm trying to get a head start on configuring the post as it's going to be late next week when the dealer comes out to commission the machine and I can't switch it on until then. I've done a simple drawing and created a program using a post that's supplied in the software. This is a section of it. It doesn't seem to be outputting tool numbers, is this correct. Can anyone tell if this would work or throw up errors. Any help is greatly appreciated.

%
N1 1234
N2 (NOTES - XYZ 710 TEST)
N3 G00 G40 G49 G80
N4 G00 G90 G54
N5 T="40MM FACE MILL"
N6 M06
N7 T="(TOP FACE)
N8 "
N9 G90 G40 G64 SOFT G54
N10 S5000 M03
N11 M08
N12 G00 X72. Y-37.5 Z5.
N13 Z3.
N14 G01 Z0. F1500.0 S5000
N15 X-72.
N16 G00 Z5.
N17 X72. Y-12.5
N18 Z3.
N19 G01 Z0.
N20 X-72.
N21 G00 Z5.
N22 X72. Y12.5
N23 Z3.
N24 G01 Z0.
N25 X-72.
N26 G00 Z5.
N27 X72. Y37.5
N28 Z3.
N29 G01 Z0.
N30 X-72.
N31 G00 Z5.
N32 M05 M09

[rbck]

hello , I'm Renato
It was purchased in my company a CNC hobbing with SIEMENS 810D system , and I do programming in CAMWorks 2014 ,
but have no post processor for this system , someone could help me get this post processor