[Jfehr]

I have an Amada Laser with a Fanuc 160i controller that I am attempting to connect with FabriTalk to. However going through the parameter setup I do not see the parameters for setting up IO CHANNLE 0 or 1 0101, 0102, 0103 when in PWE mode. Am I missing something, They were visible several days ago. The only parameter change has been setting from Tape type 3 to RS-232 Type 4.

An help or thoughts is much appreciated. Jeff

[ifixcnc]

parameters for setting up IO CHANNEL 0 is normally on the Handy page, hit the offset key multiple times.

[Jfehr]

Is this a different screen that shows paramtet 0000 through 0100. It then jumps from 0100 to 0300.

[ifixcnc]

I have a couple 160i controllers on Milling machines, maybe lasers are set up different. Can you post a picture?

[Jfehr]

I got it . It was actually on the System page. You went to the Handy and then hit system. Thanks for the help.

[wallman200]

I have an Amada Laser with a Fanuc 160i controller that I am attempting to connect with FabriTalk to. However going through the parameter setup I do not see the parameters for setting up IO CHANNLE 0 or 1 0101, 0102, 0103 when in PWE mode. Am I missing something, They were visible several days ago. The only parameter change has been setting from Tape type 3 to RS-232 Type 4.

An help or thoughts is much appreciated. Jeff

I have (2) Amada lasers and I am not able to get them to work with rs232 what software and cabling are you using?

[AMADAJOE]

I have (2) Amada lasers and I am not able to get them to work with rs232 what software and cabling are you using?

I use 9pin - 25pin Null Modem cable with a basic communication software. We sell a basic software if you cant find a free download.


Exec Memory Software/Multiple Control (API A8665) - Mounts & Retrofits | Alternative Parts Inc.

[wallman200]

I use 9pin - 25pin Null Modem cable with a basic communication software. We sell a basic software if you cant find a free download.


Exec Memory Software/Multiple Control (API A8665) - Mounts & Retrofits | Alternative Parts Inc.

Thank you sir, I am currently working on the communication issues. I may follow up with you on the software.

[memoryman]

Why use a serial connection on an i-control? You can use the pc-card (next to the monitor) instead.

[wallman200]

Thank you..... I totally forgot it was there. Set up controler and we are loading programs again.:banana:.... Thank you for your help.