[GiwrgosP]

Hi everyone!
After clearing the BBU-RAM in Haas TM-1, our machine's serial number was erased. Checking our Parameter List, Parameter #27 Serial Number is "0".

Would it be valid if we re-enter our previous serial number in parameter #27 manually?

Thank you!
George

[Kool Parts]

Try
Settings
Type in "26"
Arrow down
Should be your serial number
Gary

[haastec]

Hi everyone!
After clearing the BBU-RAM in Haas TM-1, our machine's serial number was erased. Checking our Parameter List, Parameter #27 Serial Number is "0".

Would it be valid if we re-enter our previous serial number in parameter #27 manually?

Thank you!
George

If SETTING 26 reads zero, not parameter 27, then yes you can type in the correct serial number over the zero. While in E-Stop, highlight SETTING 26, type in the machine serial number (found on the ID plate at the back of machine), then press enter. The serial number should be updated. Note: make sure you type it in correctly, because once updated, you cannot change it again.