[jonesturf]

I just picked up a used machine (Hardinge Conquest 42) with OT-B and it came with some parameters but as I'm finding out not all of them. The guy who had it before me did a reset/delete on it before I picked it up. I don't have it under power yet but I'm sure it's missing the NC and diagnostics parameters. I didn't realize there were nore than it came with. I knew it had an issue going in and it was priced accordingly but I would like to get it running. I've been able to find the OT-C/D manuals but not OT-B specific. Any help is appreciated.

[jonesturf]

Was there even a OT-B paramter manual? I can't seem to find a reference to it anywhere. The OT-A either. Wondering if the OT-Cs are the same. I would certainly buy it. I guess I will call Fanuc Monday.

[guhl]

I have -TB manual on paper and I compared 0-TC and 0-TB manuals
thy similar, you can use parameter and programming manual from TC for TB
did you try to find manual for 0-C on internet?

[jonesturf]

I found it. Pretty sure the 0-C is the same, at least close enough for what I need. Thanks

[guhl]

ask me if ou need and I peek in my manual to compare
moreover my friends have programming manual for 0i-TC in russian and it helps them in programming 0-TB

[jonesturf]

Appreciate that. If it comes to a specific one I'm not sure of I may.

Sent from my SM-N920V using Tapatalk