I've taken up my cnc plasma build after a 6 month break due to my old plasma crapping out.
I brought a (Australian brand) BOC 100 amp unit.
I've had all the electronics working for some time now using the machine to scribe sheets.
I finally got a plasma hooked up today.
When to cut a line test.
Got through 3 lines and the motors stopped working.
I stopped the machine and reset Mach.
Motors came back to good and tried again. Got through 4 lines and same thing motors stopped.
Not I can't get them to work again
I've reset everything. Still no good.
I change driver on one of the motors and it works.
So leads me to believe the drivers have crap them self.
Now could this be caused from electrical noise?
Sent from my iPhone using Tapatalk