[cmp79]

Hi All

I have an Okuma LT10 7000L, in the last few days it has been alarming out. It will alarm out when running and not running after about 20 minutes

Alarm code 1208 BDU overload, when I check in the book it tells to check slave station 13, which I have done but I don't know what i am looking at.

The first image is before it trips





The second image is after the alarm triggers




Can anyone tell me what i should be looking for.


Thanks

[OkumaWiz]

Your axis drive unit is overloading. Check your axis loads to see if they are unusually high. If they are, check for something restricting axis movement such as packed chips, binding covers, etc. If the loads are not high, check to see if the BDU fans are functioning. If they get gummed up and stop, this alarm will also occur.

Best regards,

[cmp79]

Your axis drive unit is overloading. Check your axis loads to see if they are unusually high. If they are, check for something restricting axis movement such as packed chips, binding covers, etc. If the loads are not high, check to see if the BDU fans are functioning. If they get gummed up and stop, this alarm will also occur.

Best regards,

Thanks, i will check all the fans and slide ways are clear.