Hello everyone,
In the absence of a carving bit can I use a 60 degree v bit?
If so, how do I set up stepover parameter.
I use RhinoCam.
Thank you.
Tolu.
Hello everyone,
In the absence of a carving bit can I use a 60 degree v bit?
If so, how do I set up stepover parameter.
I use RhinoCam.
Thank you.
Tolu.
No; it's not the same thing at all. You can use a ball-nose endmill, but the ends of those V-carving bits are sharp, so you'd get lines all over your carving.