I'm very new to this program. I haven't had any formal training nor do I have any training manuals for it. I've watched a couple of videos on youtube and made it ths far. I'm trying to create an oring groove into a flat surface. I've contured the inside and outside of the groove because it has to be a certain width. problem is that when I do a cut part rendering it leads the cut in from the side and exits the side creating two little dimples in the finished product. I've guessed and selected about every solution I can think of. Any ideas? I'll attach the file here if it's that simple to do. Oh yeah, I'm using the 2007 version of the program.