Hello everybody.
I'm experiencing an issue on a Mazatrol 640MT fitted on an Integrex.
Previously I had a Hard disk drive failure. I've fixed it by replacing a SMD fuse on the HDD PCB.
I've made a ghost backup of the HDD. And try to restore it to a new one but doesn't work.
So problem was solved, everything works fine. OK. Next =>
Few months later, battery alarm.
Replacing it by a rechageable battery 110mAh (bad idea!) no recharge circuit in the HR083 board!!!
So replaced by a lithium battery 2Ah.
But I had to restore all parameters via tool in "Mainte" folder.
OK ok
BUT a remaining failure on the ATC (Tool changer) exist. Because of home is not set!!! Normal for the moment.
So, I want to open MR-J2-CT-M6 Setup S_W but it's impossible. It answer me "The installation did not end normally" and close.
I'm not able to reinstall it and ghost copy doesn't work better.
Do you have this software?
FWS-B05B015 (BUS CONNECTION)
Do I need another file or program installed with? I've seen VBRun300.dll file inside the J2CTBUS.
I've found the J2CTCOM software but I need the M6 one
Many thanks for your help or suggestions. :wave: