[millathes]

Hello everybody

im using a sinker EDM to make my project and i need a mirror finish because its impossible to polish the part afther
i got a copper electrode on a steel workpiece

if someone know some parameter for help me ....i got a " not bad" finish but im looking for better

thank a lot

[mactec54]

Hello everybody

im using a sinker EDM to make my project and i need a mirror finish because its impossible to polish the part afther
i got a copper electrode on a steel workpiece

if someone know some parameter for help me ....i got a " not bad" finish but im looking for better

thank a lot

Your EDM machine would have to have that capability, it's not something all EDM machines can do, on the older machines it was a add on extra, check your manual to see if your machine has mirror finishing

[millathes]

my machine is a knuth edm znc 250 and i got a button mirror on the controller but i dont know how to set it up

[mach6]

Our company just bought this same machine and nobody knows how to operate it. The manual is very basic about setup and the price for someone from the company to come in for training is too expensive for our small shop. D you have any information or know of any videos that would be helpful? I would appreciate any help.